cut-off voltage

The main control system includes the synchronous signal generating circuit 、 the testing circuit of thyristor cut-off voltage and the trigger circuit of the thyristors etc.

论述了主要硬件电路的设计方案，其中包括晶闸管两端电压检测、三相电源同步信号检测等。

This paper briefly introduces the basic principles to measure plancks constant by photoemission and the three methods to measure cut-off voltage.

本文简单介绍了光电效应测普朗克常数实验的基本原理及测量截止电压的三种方法。

The determination of the cut-off voltage of VRLA battery applied in access net at low discharge current was introduced in brief.

对接入网电池在小电流使用状态下终止电压的确定作了简单地介绍。

The differences of comparatively light duty discharge time and discharge time of lower cut-off voltage of different batteries were not significant.

较轻负载的放电性能与低截止电压的放电时间差异不大。

Determining Cut-off Voltage Properly and Measuring Planck Constant

正确确定遏止电压测量普朗克常数

When every step cut-off voltage decreases to 850 mV, the batteries have over discharged and the leaking proportion increases.

当每步放电截止电压降低到850mV时，电池已经过放，会提高化成时的漏液比例。

In this work the effect of discharging conditions such as the cut-off voltage and resistance on the zinc concentration in the cathodic compartment was studied.

通过改变放电电压、电阻等条件，研究了正极区中锌浓度的影响因素。